MIDI Breakout Board MV
The MIDI 2.0 Breakout board is an easy way to connect a hardware MIDI device to an Arduino, microcontroller or just about any embedded computer. The board comes with a 2.54mm header already installed or you can remove it to solder wires directly. There are mounting holes for a more permanent installation. Use 4 wires to hook up, power, ground, Rx (MIDI in), and Tx (MIDI out).
- MIDI IN and MIDI OUT
- 5V or 3.3V operation
- Input is optically isolated
- Full Assembled Breakout Board
- 2.54mm Header
- TRRS Jacks
Documentation / Support
This work is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.
… Well then Visit the support forums.